Diferencia entre revisiones de «Minicube-II B1: Assembly»
De WikiRobotics
(→Pasos 2: Conectar el servo del Módulo MY1 a la Skycube) |
(→Introduction) |
||
Línea 12: | Línea 12: | ||
{| | {| | ||
− | || [[Imagen:Minicube-IIB-inicio-r2.jpg|thumb|300px|'''Begining''': Parts needed to build Minicube-II type | + | || [[Imagen:Minicube-IIB-inicio-r2.jpg|thumb|300px|'''Begining''': Parts needed to build Minicube-II type B1 (''Click to enlarge'')]] |
|| [[Imagen:Minicube-IIB-fin-r2.jpg|thumb|300px|'''End''': Minicube-II finished (''Click to enlarge'')]]]] | || [[Imagen:Minicube-IIB-fin-r2.jpg|thumb|300px|'''End''': Minicube-II finished (''Click to enlarge'')]]]] | ||
|} | |} |
Revisión del 12:22 23 feb 2011
Contenido
Introduction
Minicube-II is a minimal configuration. It is the modular robot with the minimum number of modules capable of moving in 2D.
To build it, the following parts are needed:
- One MY1 module (Assembly instructions)
- One Unimod 2D type B1 (Assembly instructions)
- 4 M3 bolts. Length: 8mm
- 4 M3 nuts
]] |
Assembling
Step 1: Screw the MY1 module to Unimod 2D B1
Step 2: Connect the module's servo to the Skycube board
Connect the module's servo to the Skycube. It can be connected to any of the available headers.
IMPORTANT! Connect the servo in the right orientation. The black wire is connected to GND |
Fotos
Álbum de fotos |
Enlaces
Noticias
- 19/Abril/2010: Primera versión de esta página